The Dinosaur theme had two prints each on sand-green and sand-blue. Just remember that the old body style has seen limited use over the years. So, there is no way you're going to get the modern bodies to work with the old limbs, but the modern limbs _should_ be able to plug into the old bodies. The limb has the mating section of the ratchet system, but it's set in flush with the connecting surface of the limb. There's a sleeve that's part of the ratchet system that sticks out a bit from the surface of the body. ![]() It uses a much more compact ratchet system that always uses a Technic pin connection. ![]() The necks (where needed) and tails connect with a ball-shaped terminus that fits into a neck sleeve.įor the modern dinosaurs, you can see the mating halves in the parts pic for the Indoraptor. So, the holes had to be proper Technic pin holes for those to work. The Mosasaur had fins that only connected by pins, and any bipedal dinosaurs had the old dragon forelegs that also connected by pins. Now, the holes that these buttons interfaced with _were_ Technic holes. The ratchet system was really wide, around 3 studs in diameter. They didn't use pins at all, but rather had buttons that would grip the pin holes, and relied on the fact that each leg set worked as a single element that would grip the body like a minifig hand grips a bar. After you built the core body, the legs would snap on around it. ![]() The bodies were quartered, with two elements. If you check any of the inventories for 6719-6722, you can see what the legs look like.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |